3. Use a stud finder to locate the wall studs. Use a pencil to mark the stud locations at least 6 inches above and below the line for the bottom of the wall cabinets. Draw straight vertical lines between the top and bottom marks to indicate the center of the studs.
9. If your cabinets end up butting against another wall, you may need a filler strip to make up the last few inches. If you have custom cabinets, they should have been built to fill this gap, but if you are using stock or RTA Kitchen Cabinets the filler strip may be needed. If you do need to use a filler strip, leave the last cabinet detached from the other cabinets. Clamp a straightedge to the face of the nearest installed unit, extending far enough for you to put alignment marks on the end wall. Allow a 3/4" offset behind those marks (for the thickness of the filler piece) and fasten a cleat to the wall. Then install and fasten the last cabinet and measure the gap between its face frame and the wall.
In a kitchen renovation, the kitchen cabinets represent the largest expenditure in your remodeling budget. Since they are the centerpiece of your kitchen, many of the other decisions about your kitchen will be based off of your cabinet choice. Your countertop, appliance, and hardware decisions will depend on the style and layout of your kitchen cabinets.
Kitchen Design Monday , May 14th , 2018 - 01:43:41 AM
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does homebusinessguide.us claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.